Login
Shipping Country
Super CLEARANCE CAMPAIGN - Selected tools and accessories with Super Special prices! - CHECK HERE
READ MORE
Login
SA-OFL3.0 + Mafell FM 1000 (MAF9M0001)
A router motor mounted under the table is a precise machine but awkward to set: the cutter height has to be found from below, and changing a bit means releasing the machine. A router lift moves both above the table. Height is set through a threaded spindle, which makes the setting repeatable and stops it drifting during the cut.
The OFL3.0 tilts -5° to +50° and locks at the classic angles of 22.5°, 30°, 45° and 90°. The manufacturer highlights the consequence: chamfers, tapers, grooves and mitre cuts are produced with a single slot cutter by tilting it, where otherwise each angle would need its own profile bit. The pivot also costs no routing depth.
Height is set from above with the rotary handle; angle locking and centring in the slotted hole are done with levers underneath. Bit changes are easy because the spindle and collet chuck look upwards.
| Pivot range | -5° to +50°, snap-in points 22.5° | 30° | 45° | 90° |
| Insert plate | 306 × 229 × 9 mm, corner radius 6 mm |
| Height adjustment per rotation | 4 mm |
| Max. adjustment travel | 74 mm |
| Height, fully extended | 240 mm |
| Max. router bit diameter | Ø 55 mm |
| Fine adjustment | to 1/10 mm |
| Motor clamping neck | Ø 43 mm |
| Weight | approx. 5 kg |
| Made in | Germany |
The lift takes a router motor with a Ø 43 mm clamping neck. Directly compatible and approved by the manufacturer:
The Mafell FM1650PV-LO is not compatible. If your motor is not listed, check the clamping neck tolerance stated by its manufacturer before ordering.
The opening around the cutter should be only as large as the cutter needs. Too large an opening leaves the workpiece unsupported at the cut: a narrow strip wants to drop into the hole and the surface tears. The OFL3.0's reducing plates are held by magnets, so they change in seconds without screws.
The insert plate is 306 × 229 mm, Sauter's standard outline — so the lift fits almost every router table and is interchangeable with earlier insert plates. The plate is levelled with adjusting screws. The manufacturer offers a mounting kit SA-99600005 (4 corner plates, 4 countersunk screws, 12 wood screws) and a sheet-steel levelling frame SA-99600006 for permanent levelling.
You'll get 210.99 rewardpoints
The pivoting OFL3.0 router lift and Mafell's FM 1000 spindle motor as a matched pair. The Mafell FM 1000 is on Sauter's own compatibility list, and its 43 mm clamping neck goes straight into the lift — no adapters needed.
100% Trustworthy online store with history
Expert customer service
Fast deliveries
Large selection directly from stock
No middlemen - save on the price
Suomeksi
På Svenska
add to cart
Add to wish list